INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT AUTO SLIDE DOOR CONTROL SWITCH ASSEMBLY (for RH Side) |
Check the resistance.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
8 - 1
Switch ON
Below 1 Ω
8 - 1
Switch OFF
10 kΩ or higher
Check the illumination operation.
Apply battery voltage to the auto slide door control switch assembly and check that the illumination comes on.
- Standard:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 7
Battery negative (-) → Terminal 6
LED illuminates
Text in Illustration *a
Component without harness connected
(Auto Slide Door Control Switch Assembly (for RH Side))
| INSPECT AUTO SLIDE DOOR CONTROL SWITCH ASSEMBLY (for LH Side) |
Check the resistance.

Measure the resistance and check the results in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
4 - 1
Switch ON
Below 1 Ω
4 - 1
Switch OFF
10 kΩ or higher
Check the illumination operation.
Apply battery voltage to the auto slide door control switch assembly and check that the illumination comes on.
- Standard:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2
LED illuminates
Text in Illustration *a
Component without harness connected
(Auto Slide Door Control Switch Assembly (for LH Side))
