2014-2019 Hiace · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT TIRE PRESSURE WARNING RESET SWITCH

  1. C357307E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 6
    Tire pressure warning reset switch pressed
    Below 1 Ω
    Tire pressure warning reset switch not pressed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Tire Pressure Warning Reset Switch)
    If the result is not as specified, replace the tire pressure warning reset switch.

  1. C357308E01
    Apply battery voltage between the terminals of the tire pressure warning reset switch, and check the illumination condition.

    Standard:
    Measurement Condition
    Switch Condition
    Battery positive (+) → 5 (ILL+)
    Battery negative (-) → 4 (ILL-)
    Illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Tire Pressure Warning Reset Switch)
    *b
    Tire Pressure Warning Reset Switch Illumination
    If the result is not as specified, replace the tire pressure warning reset switch.

← REMOVAL (from Jan 2017)INSTALLATION (from Jan 2017) →