2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

  1. A231913
    Remove the 2 bolts and disconnect the vane pump oil reservoir.


2. LOOSEN FAN PULLEY
  1. Loosen the 4 nuts from the fan pulley.


3. REMOVE FAN AND GENERATOR V BELT

  1. A156649E01
    Remove the drive belt by rotating the tensioner pulley clockwise to loosen its tension with the pulley set bolt of the tensioner.


4. REMOVE FAN PULLEY
  1. Remove the 4 nuts and fan pulley.


5. REMOVE CRANKSHAFT POSITION SENSOR

  1. TYPE A:

    A307644E01

    Text in Illustration 
    *1
    Clamp
    *2
    Wire Harness Clamps (A)
    *3
    Wire Harness Clamps (B)
    *4
    Wire Harness Clamps (C)

    1. Detach the 2 wire harness clamps (B, C).

    2. Disconnect the crankshaft position sensor connector.

    3. Detach the crankshaft position sensor connector from the No. 1 vacuum transmitting pipe.

    4. Remove the clamp.

      NOTICE:
      1. Make sure that no portion of the clamp remains in the clamp installation hole. If there is any portion of the clamp remaining, remove it.
      2. Do not reuse the clamp.

    5. Remove the bolt and crankshaft position sensor.

    6. Remove the wire harness clamp (A) from the crankshaft position sensor.

  1. TYPE B:

    A307359E01

    Text in Illustration 
    *1
    Clamp
    *2
    Bracket (Clamp)
    *3
    Wire Harness Clamps (A)
    *4
    Wire Harness Clamps (B)
    *5
    Wire Harness Clamps (C)
    -
    -

    1. Detach the 2 wire harness clamps (B, C).

    2. Disconnect the crankshaft position sensor connector.

    3. Detach the crankshaft position sensor connector from the No. 1 vacuum transmitting pipe.

    4. Remove the clamp.

      NOTICE:
      1. Make sure that no portion of the clamp remains in the clamp installation hole. If there is any portion of the clamp remaining, remove it.
      2. Do not reuse the clamp.

    5. Remove the bolt and bracket (clamp).

    6. Remove the bolt and crankshaft position sensor.

    7. Remove the wire harness clamp (A) from the crankshaft position sensor.

    8. Detach the 2 wire harness clamps from the bracket (clamp).

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →