2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT COOLING FAN SWITCH

  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      A108624E17

  1. Measure the resistance between the terminals.

    Standard resistance:
    Condition
    Specified Condition
    1 (E2) - 2 (THW)
    2.32 to 2.59 kΩ at 20°C (68°F)
    1 (E2) - 2 (THW)
    0.310 to 0.326 kΩ at 80°C (176°F)

    NOTICE:
    When checking the cooing fan switch in water, be careful not to allow water to enter the terminals. After checking, wipe the sensor dry.
    If the result is not as specified, replace the cooling fan switch.

← REMOVAL (from Apr 2016)INSTALLATION (Oct 2014 – Mar 2016) →