INSTALLATION
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL FUEL COOLER |
![]() ![]() |
Install the fuel cooler with the 3 bolts.
- Torque:
- 18 N*m{ 180 kgf*cm , 13 ft.*lbf }
Connect the 2 fuel hoses to the fuel cooler.

| 2. INSPECT FOR FUEL LEAK |
Perform the Active Test.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
Perform the Active Test.
Tester Display
Test Part
Control Range
Diagnostic Notes
Test the Fuel Leak
Pressurize common rail interior and check for fuel leaks
Stop/Start
- Fuel pressure inside common rail increased to specified value and engine speed increased to 2000 rpm when Active Test is performed
- Above conditions preserved while Active Test is being performed
- Fuel pressure inside common rail increased to specified value and engine speed increased to 2000 rpm when Active Test is performed

