INSTALLATION
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Inspect the compression spring.

Using vernier calipers, measure the free length of the compression spring.
- Minimum length:
- 40.5 mm (1.594 in.)
Fully insert a new gasket into the exhaust manifold converter by hand.

Using a wooden block, uniformly strike the gasket so that the gasket and exhaust manifold converter are properly fitted.
- NOTICE:
- Install the gasket in the correct direction.
- Do not damage the outer surface of the gasket.
- Do not reuse the removed gasket.
- Do not push in the gasket with the front exhaust pipe when connecting it.
- Install the gasket in the correct direction.
Connect the front exhaust pipe to the No. 4 exhaust pipe support.
Install the front exhaust pipe and 2 compression springs with the 2 bolts.
- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }
| 2. INSTALL CENTER EXHAUST PIPE ASSEMBLY (for Super Long Wheelbase) |
Connect the center exhaust pipe to the 3 No. 4 exhaust pipe supports.
Install a new gasket to the front exhaust pipe.
- NOTICE:
- Do not reuse the gasket.
Connect the center exhaust pipe to the front exhaust pipe.
Install the 2 bolts and 2 new nuts.
- Torque:
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
| 3. INSTALL TAILPIPE ASSEMBLY (for Long Wheelbase) |
Connect the tailpipe to the 4 No. 4 exhaust pipe supports.
Install a new gasket to the front exhaust pipe.
- NOTICE:
- Do not reuse the gasket.
Install the 2 bolts and 2 new nuts.
- Torque:
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
| 4. INSTALL TAILPIPE ASSEMBLY (for Super Long Wheelbase) |
Connect the tailpipe to the No. 4 exhaust pipe support.
Install a new gasket and the tailpipe to the center exhaust pipe.
- NOTICE:
- Do not reuse the gasket.
Install the 2 bolts.
- Torque:
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
| 5. INSPECT FOR EXHAUST GAS LEAK |
