2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT DPF SWITCH ASSEMBLY

  1. A266069E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Connection
    Specified Condition
    3 - 4
    Switch OFF
    10 kΩ or higher
    3 - 4
    Switch ON
    Below 1 Ω

    If the result is not as specified, replace the DPF switch assembly.

  1. Apply battery voltage to the switch connector and check that the DPF switch illuminates.

    OK:
    Measurement Condition
    Switch Condition
    Apply the battery voltage terminal 1 (+) and 2 (-)
    Mark illumination illuminates
    Apply the battery voltage terminal 5 (+) and 6 (-)

    If the result is not as specified, replace the DPF switch assembly.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →