2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT DPF SWITCH ASSEMBLY

  1. A396484E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Connection
    Specified Condition
    3 - 4
    Switch OFF
    10 kΩ or higher
    3 - 4
    Switch ON
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (DPF switch assembly)
    If the result is not as specified, replace the DPF switch assembly.

  1. Apply battery voltage to the switch connector and check that the DPF switch illuminates.

    OK:
    Measurement Condition
    Switch Condition
    Apply the battery voltage terminal 1 (+) and 2 (-)
    Mark illumination illuminates
    Apply the battery voltage terminal 5 (+) and 6 (-)

    If the result is not as specified, replace the DPF switch assembly.

← REMOVAL (from Jan 2017)INSTALLATION (from Jan 2017) →