INSPECTION
Inspection · Vehicles built from Jan 2017
| INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY |
Perform a visual check for any foreign matter on the temperature sensor (thermistor) of the intake mass air flow meter sub-assembly shown in the illustration.

- OK:
- There is no foreign matter.
If the result is not as specified, replace the intake mass air flow meter sub-assembly.Text in Illustration *a
Thermistor
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
4 (THA) - 2 (E2G)
-20°C (-4°F)
13.6 to 18.4 kΩ
20°C (68°F)
2.21 to 2.69 kΩ
60°C (140°F)
0.49 to 0.67 kΩ
If the result is not as specified, replace the intake mass air flow meter sub-assembly.Text in Illustration *a
Component without harness connected
(Intake Mass Air Flow Meter Sub-assembly)
