2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT TURBOCHARGER MOTOR

  1. A148800E01
    Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 (M-) - 2 (M+)
      1 to 100 Ω at 20°C(68°F)

      If the result is not as specified, replace the turbocharger.


VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY

  1. A220776E01
    Check for deformation and cracks in the turbine wheel on the exhaust side.
    If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.
    Text in Illustration 
    *1
    Turbine Wheel


INSPECT AXIAL PLAY OF TURBINE SHAFT

  1. A110334
    Using a dial indicator, insert the needle of the dial indicator into the exhaust side of the turbine shaft.

  1. Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft.

    NOTICE:
    Turbocharger sub-assembly and dial indicators are surely fixed when performing measurement.

    Maximum axial play:
    0.11 mm (0.0043 in.)

    If the axial play is greater than the maximum, replace the turbocharger sub-assembly.


CHECK TURBINE SHAFT ROTATION

  1. A229649
    Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.

    HINT:
    Even if it takes effort a little to rotate the turbine wheel, this is not a problem.

    If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.

← REMOVAL (from Apr 2016)INSTALLATION (Oct 2014 – Dec 2014) →