2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built Oct 2014 – Dec 2014


1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and No. 1 engine under cover.


2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C295043
    Remove the clip and nut, and disconnect the transmission control cable assembly from the control shaft lever and transmission control cable bracket No. 1.

  1. C101804E02
    Remove the 2 bolts and disconnect the transmission control cable assembly.
    Text in Illustration 
    *a
    Front

  1. C101807E02
    Disconnect the transmission control cable assembly from the transmission control cable bracket No. 2.
    Text in Illustration 
    *a
    Front

  1. Remove the 2 nuts and transmission control cable bracket No. 2 from the body.


3. REMOVE SHIFT LEVER KNOB

  1. C299519
    Twist the shift lever knob in the direction indicated by the arrow and remove it.


4. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY

  1. C299520
    Detach the 8 claws and remove the floor shift position indicator housing sub-assembly.


5. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 1

  1. B365546
    Using a clip remover, remove the 2 clips

  1. Detach the 3 claws and remove the instrument panel under cover sub-assembly No. 1.


6. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER

  1. B365544
    Using a clip remover, remove the 2 clips.

  1. Detach the 4 clips and remove the instrument panel finish lower.

  1. Disconnect each connector.

  1. B102838
    Push the positions indicated by the arrows in the illustration to disconnect the fuel lid lock control cable and bonnet (hood) control cable assembly from the instrument panel finish lower.


7. REMOVE PARKING BRAKE HOLE COVER

  1. B365547
    Detach the 6 claws and remove the parking brake hole cover.

  1. Disconnect each connector.


8. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER

  1. B365551E01
    Detach the 8 claws and remove the instrument panel finish panel lower center.
    Text in Illustration 
    *A
    for Manual Transmission
    *B
    for Automatic Transmission


9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C299522
    Disconnect the end of the transmission control cable assembly from the shift lock control unit assembly.

  1. C299523
    Using a screwdriver, pull out the stopper of the transmission control cable assembly.

    HINT:
    Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

  1. C299524
    Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lock control unit assembly.

    NOTICE:
    Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

  1. C101806E01
    Disconnect the transmission control cable assembly from the transmission control cable bracket No. 3.
    Text in Illustration 
    *a
    Front

  1. Remove the 2 nuts and transmission control cable bracket No. 3 from the body.

  1. C101805E02
    Rolled up the floor carpet of the front seat LH and remove 2 bolts and transmission control cable assembly.
    Text in Illustration 
    *a
    Front

← COMPONENTS (Oct 2014 – Dec 2014)INSTALLATION (Oct 2014 – Dec 2014) →