2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT NO. 2 EGR VALVE ASSEMBLY

  1. A240559E01
    Apply vacuum and check that the rod of the No. 2 EGR valve operates as shown in the illustration.
    If the rod does not operate, replace the No. 2 EGR valve.

  1. When a vacuum of 59 kPa (443 mmHg, 17 in.Hg) is applied to the diaphragm chamber, check that the valve turns and air flows out.


INSPECT VACUUM CONTROL VALVE (for EGR Bypass Valve)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C
    33 to 39 Ω

    If the result is not as specified, replace the vacuum control valve.

  1. Check operation of the vacuum control valve set.

    1. G037162E04
      Check that air flows from port E to the filter.
      If the result is not as specified, replace the vacuum control valve.

    2. A110309E05
      Apply battery voltage to the terminals.

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the vacuum control valve.

← REMOVAL (from Jan 2017)INSTALLATION (Oct 2014 – Dec 2014) →