REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. REMOVE NO. 2 ENGINE SERVICE HOLE COVER |
Detach the clips and fold back the carpet.
Remove the 3 bolts and No. 2 engine service hole cover.

| 2. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and oil pan drain plug.
Install a new gasket and the oil pan drain plug.
- Torque:
- 34 N*m{ 347 kgf*cm , 25 ft.*lbf }
| 3. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY |
Disconnect the oil pressure sender gauge connector.
Using a 27 mm deep socket wrench, remove the oil pressure sender gauge.

