2014-2019 Hiace · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built Oct 2014 – Dec 2014


INSPECT SHIFT SOLENOID VALVE SLT

  1. C209928E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    5.0 to 5.6 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve SLT)

  1. Apply 12 V of battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.

    OK:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) with a 21 W bulb → Terminal 2
    1. Battery negative (-) → Terminal 1
    Valve moves and makes an operating noise

    If the result is not as specified, replace the shift solenoid valve.


INSPECT SHIFT SOLENOID VALVE SL

  1. C238276E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Shift solenoid valve SL connector terminal - Shift solenoid valve SL body
    20°C (68°F)
    11 to 15 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve SL)

  1. Apply 12 V of battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.

    OK:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) → Shift solenoid valve SL connector
    1. Battery negative (-) → Shift solenoid valve SL body
    Valve moves and makes an operating noise

    If the result is not as specified, replace the shift solenoid valve.


INSPECT SHIFT SOLENOID VALVE S1 AND S2

  1. C238275E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Shift solenoid valve connector terminal - Shift solenoid valve body
    20°C (68°F)
    11 to 15 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve S1 and S2)

  1. Apply 12 V of battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.

    OK:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) → Shift solenoid valve connector
    1. Battery negative (-) → Shift solenoid valve body
    Valve moves and makes an operating noise

    If the result is not as specified, replace the shift solenoid valve.

← DISASSEMBLY (Oct 2014 – Dec 2014)REASSEMBLY (Oct 2014 – Dec 2014) →