2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY
  1. Install the differential pressure sensor and sensor bracket with the nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. A332158E01
    Install the differential pressure sensor with the nut.
    Text in Illustration 
    *a
    No. 1 Exhaust Pipe Support Bracket Hole
    *b
    Differential Pressure Sensor Assembly Tab

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    NOTICE:
    When installing, align the tab of the differential pressure sensor assembly with the hole of the No. 1 exhaust pipe support bracket.

  1. A262920E01
    Install the No. 1 exhaust pipe air hose and No. 7 exhaust pipe air hose to the differential pressure sensor with 2 new clips.

    HINT:
    1. Connect the air hoses so that the paint marks of the air hoses are as shown in the illustration.
    2. Make sure the clip labeled A is 14.3 mm (0.563 in.) or less from the end of the exhaust pipe air hose when installing the clip.
    3. Make sure the clip labeled B does not protrude beyond the end of the hose as shown in the illustration.

  1. Connect the differential pressure sensor connector.

← REMOVAL (from Oct 2014)COMPONENTS (from Oct 2014) →