2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Oct 2014 – Mar 2016

Versions by build date: Oct 2014 – Mar 2016 from Apr 2016


1. REMOVE EXHAUST TAILPIPE ASSEMBLY

  1. A239811
    Remove the 2 bolts.

  1. Disconnect the tailpipe from the center exhaust pipe and remove the gasket.

  1. Remove the tailpipe from the exhaust pipe support.


2. REMOVE CENTER EXHAUST PIPE ASSEMBLY

  1. A242059
    Remove the 2 bolts and 2 compression springs.

  1. Disconnect the center exhaust pipe from the 3 exhaust pipe supports.

  1. Remove the gasket.


3. REMOVE AIR TUBE COVER

  1. A239116
    Remove the 2 bolts.

  1. Detach the 2 clips and clamp, and remove the air tube cover.


4. REMOVE AIR FUEL RATIO SENSOR

A231917
  1. Disconnect the air fuel ratio sensor connector and detach the clamp.

  1. A231918E01
    Using SST, remove the air fuel ratio sensor from the front exhaust pipe.
    SST
    09224-00010  


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the exhaust gas temperature sensor connector and detach the clamp.

  1. Disconnect the No. 2 exhaust gas temperature sensor connector and detach the 2 clamps.

  1. Disconnect the No. 3 exhaust gas temperature sensor connector and detach the 2 clamps.

  1. A262923
    Disconnect the No. 1 exhaust pipe air hose and No. 7 exhaust pipe air hose from the front exhaust pipe.

  1. A239813
    Remove the 2 No. 4 exhaust pipe supports.

  1. Remove the 3 nuts and front exhaust pipe.

  1. Remove the gasket.


6. REMOVE EXHAUST GAS TEMPERATURE SENSOR

A239815

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor.


7. REMOVE NO. 2 EXHAUST GAS TEMPERATURE SENSOR

A239814

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor.


8. REMOVE NO. 3 EXHAUST GAS TEMPERATURE SENSOR

A239816

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor.


9. REMOVE NO. 1 EXHAUST PIPE PROTECTOR

  1. A177121
    Remove the 3 bolts and No. 1 exhaust pipe protector.


10. REMOVE NO. 2 EXHAUST PIPE PROTECTOR

  1. A177122
    Remove the 2 bolts and No. 2 exhaust pipe protector.


11. REMOVE CATALYTIC CONVERTER BRACKET SUB-ASSEMBLY

  1. A239817
    Remove the bolt and catalytic converter bracket.

← COMPONENTS (from Apr 2016)REMOVAL (from Apr 2016) →