ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jan 2015
| INSPECT AIR PRESSURE SENSOR |
Inspect the power source voltage.
Disconnect the air pressure sensor connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
3 (VC) - 1 (E2)
Ignition switch ON
4.75 to 5.25 V
If the result is not as specified, inspect the wire harness and ECM.Text in Illustration *a
Front view of wire harness connector
(Air Pressure Sensor)
Turn the ignition switch off.
Connect the air pressure sensor connector.
Check the pressure.
Connect a pressure gauge to the air pressure sensor as shown in the illustration.

Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Air Pump Pressure (absolute).
Check that the pressure displayed on the GTS fluctuates when applying pressure to the pressure sensor with the pressure gauge.
- OK:
- Pressure fluctuates in response to pressure applied with pressure gauge.
- HINT:
- The GTS displays the air pump pressure (Air Pump Pressure (absolute)) as absolute pressure.
