2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    A316609E01

    Text in Illustration 
    *1
    Bleeder Plug
    *2
    Radiator Reservoir Cap Sub-assembly
    *3
    Radiator Reservoir Assembly
    *4
    Cylinder Block Drain Cock Plug
    *5
    Radiator Drain Cock Plug
    -
    -

  1. Remove the radiator reservoir cap sub-assembly.

  1. Loosen the cylinder block drain cock plug (on the engine oil cooler cover), and drain the engine coolant.

  1. Tighten the radiator drain cock plug.

  1. Tighten the cylinder block drain cock plug (on the engine oil cooler cover).

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


3. REMOVE TURBINE OUTLET ELBOW
(Click here)

4. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

  1. A334696E01
    Remove the 2 bolts and No. 2 injector holder.
    Text in Illustration 
    *1
    No. 2 Injector Holder
    *2
    No. 1 Nozzle Holder Clamp
    *3
    Exhaust Fuel Addition Injector Assembly
    *4
    Injection Nozzle Seat
    *5
    No. 1 Injector Holder
    *6
    Gasket

  1. Using a T40 "TORX" socket wrench, remove the screw and No. 1 nozzle holder clamp.

  1. Remove the exhaust fuel addition injector assembly and injection nozzle seat.

  1. Remove the 3 bolts and No. 1 injector holder.

  1. Remove the gasket.

  1. Remove the E-ring, O-ring and 3 backup rings from the exhaust fuel addition injector assembly.

← COMPONENTS (from Oct 2014)REMOVAL (Jan 2015 – Mar 2016) →