2014-2019 Hiace · Service Manual ENGINE

After Treatment Control System

Circuit diagnosis · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

INSPECTION PROCEDURE


1. TAKE SNAPSHOT DURING IDLING AND 4000 RPM (PROCEDURE 1)
  1. Connect the GTS to the DLC3.

  1. Start the engine and turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Catalytic Converter.

  1. Take a snapshot of the following Data List items.

    HINT:
    1. A snapshot can be used to compare vehicle data from the time of the malfunction to normal data and is very useful for troubleshooting. The data in the list below is that of a normal vehicle, but as the data varies between individual vehicles, this data should only be used for reference.
    2. Check the Data List at idling and at 4000 rpm with no load after the engine is warmed up.


NEXT


2. READ VALUE USING GTS (CATALYST DIFFERENTIAL PRESS)
  1. Check Catalyst Differential Press in the snapshot taken in procedure 1 when the engine was running at 4000 rpm with no load.

    Result 
    Result
    Proceed to
    Catalyst Differential Press is more than 0.27
    A
    Except above
    B



B
END
A


3. REPLACE FRONT EXHAUST PIPE ASSEMBLY
  1. Replace the front exhaust pipe assembly (Click here).


NEXT


4. CATALYST RECORD CLEAR
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and turn the GTS on.

  1. Enter the menu options in this order: Powertrain / Engine and ECT / Utility / Catalyst Record Clear.


NEXT


5. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

NEXT

END


← After Treatment Control System (Dec 2015 – Mar 2016)After Treatment Control System (from Jan 2017) →