2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT HEATER SWITCH ASSEMBLY (w/ Hot Gas Heater)

  1. E289353E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (+S) - 3 (-S)
    ON
    Below 1 Ω
    6 (+S) - 3 (-S)
    OFF
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Heater Switch Assembly)
    If the result is not as specified, replace the heater switch assembly.

  1. Check the heater indicator operation.

    1. Connect the positive (+) lead from the battery to terminal 2 (IND) and the negative (-) lead to terminal 7 (E).

    2. Push the heater switch assembly, and check that the indicator light comes on.

      OK:
      The indicator light comes on.

      If the result is not as specified, replace the heater switch assembly.

  1. Check the illumination operation.

    1. Connect the positive (+) lead from the battery to terminal 5 (TAIL) and the negative (-) lead to terminal 4 (L1), and check that the illumination light comes on.

      OK:
      The illumination light comes on.

      If the result is not as specified, replace the heater switch assembly.


INSPECT IDLE UP SWITCH (w/o Hot Gas Heater)

  1. E293274E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (T) - 3 (E)
    ON
    Below 1 Ω
    6 (T) - 3 (E)
    OFF
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Idle Up Switch)
    If the result is not as specified, replace the idle up switch.

  1. Check the illumination operation.

    1. Connect the positive (+) lead from the battery to terminal 5 (TAIL) and the negative (-) lead to terminal 4 (L1), and check that the illumination light comes on.

      OK:
      The illumination light comes on.

      If the result is not as specified, replace the idle up switch.

← REMOVAL (from Jan 2017)INSTALLATION (Oct 2014 – Mar 2016) →