2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT FOR COOLANT LEAK

HINT:
  1. The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.
  2. Before performing this inspection, check that there are no engine coolant leaks from any parts other than the engine water pump assembly. If there are leaks, inspect those areas first.
  3. Perform this inspection when the engine is cold.

  1. Visually check the engine water pump assembly.

    1. Check that engine coolant is not dripping from the engine water pump assembly.

      HINT:
      1. If engine coolant is dripping, replace the engine water pump assembly.
      2. If engine coolant is not dripping, perform the following check.

  1. Inspect the area around the engine water pump assembly.

    HINT:
    Check for deposits around the drain plug of the engine water pump assembly.


    1. Remove the fan pulley (Click here).

    2. G037207E05
      Press a piece of paper towel against the drain plug and check that the paper towel is not wet and that there are no deposits on the lip of the drain plug.
      Text in Illustration 
      *a
      Water Hole
      *b
      Air Hole
      V100135
      Turn
      If the paper towel is wet, replace the engine water pump assembly.
      If the paper towel is not wet, thoroughly clean the area around the engine water pump assembly.

    3. Turn the pump pulley, and check that the engine water pump bearing moves smoothly and does not make noise.
      If necessary, replace the engine water pump assembly.

    4. Install the fan pulley (Click here).

← COMPONENTS (from Dec 2017)REMOVAL (Oct 2014 – Dec 2014) →