2014-2019 Hiace · Service Manual RESTRAINTS

DATA LIST / ACTIVE TEST

System information · Vehicles built from Oct 2014


DATA LIST

HINT:
Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Combination Meter / Data List.

  5. According to the display on the GTS, read the Data List.

    Combination MeterĀ 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P-Seatbellt Buckle SW*
    Front passenger side seat belt buckle signal / ON or OFF
    ON: Front passenger side seat belt unfastened
    OFF: Front passenger side seat belt fastened
    Perform the inspection while sitting in the front passenger side seat.
    Driver Side Seatbelt Buckle Switch
    Driver side seat belt buckle signal / ON or OFF
    ON: Driver side seat belt unfastened
    OFF: Driver side seat belt fastened
    -
    1. *: w/ Front Passenger Seat Belt Warning System


ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. According to display on the GTS, perform the Active Test.

    Combination MeterĀ 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Passenger Side Seat Belt*
    Front passenger side seat belt warning light
    OFF/ON
    Confirm that the vehicle is stopped and the engine is idling.
    Driver Side Seat Belt
    Driver side seat belt warning light
    OFF/ON
    Confirm that the vehicle is stopped and the engine is idling.
    1. *: w/ Front Passenger Seat Belt Warning System

← PROBLEM SYMPTOMS TABLE (from Jan 2017)ON-VEHICLE INSPECTION (from Oct 2014) →