ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jan 2015
| INSPECT BATTERY CURRENT SENSOR ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
2 (VC5) - 4 (E2)
Always
0.1 to 10 kΩ
2 (VC5) - 3 (IB)
0.5 kΩ or less
3 (IB) - 4 (E2)
0.05 to 10 kΩ
If the result is not as specified, replace the battery current sensor assembly.Text in Illustration *a
Component without harness connected
(Battery Current Sensor Assembly)
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (THB) - 4 (E2)
20 to 30°C
1.5 to 2.5 kΩ
If the result is not as specified, replace the battery current sensor assembly.Text in Illustration *a
Component without harness connected
(Battery Current Sensor Assembly)
*b
Resistance
*c
Temperature
