2014-2019 Hiace · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2017


1. REMOVE VALVE STEM CAP
  1. Remove the 16 valve stem caps from the cylinder head sub-assembly.

    HINT:
    Arrange the removed parts in the correct order.


2. REMOVE INTAKE VALVE

  1. A337433E01
    Using SST and wooden blocks, compress the valve compression spring and remove the valve spring retainer locks from the valve spring retainer.
    SST
    09202-00021  
    09202-70020  

  1. Remove the valve spring retainer, valve compression spring and intake valve from the cylinder head sub-assembly.

    HINT:
    Arrange the removed parts in the correct order.


3. REMOVE EXHAUST VALVE

  1. A337434E01
    Using SST and wooden blocks, compress the valve compression spring and remove the valve spring retainer locks from the valve spring retainer.
    SST
    09202-00021  
    09202-70020  

  1. Remove the valve spring retainer, valve compression spring and exhaust valve from the cylinder head sub-assembly.

    HINT:
    Arrange the removed parts in the correct order.


4. REMOVE VALVE STEM OIL SEAL

  1. A337435
    Using needle-nose pliers, remove the valve stem oil seals from the valve guide bush.


5. REMOVE VALVE SPRING SEAT

  1. A337436
    Using compressed air and a magnet hand, remove the valve spring seat from the cylinder head sub-assembly by blowing air onto it.


6. REMOVE NO. 1 STRAIGHT SCREW PLUG WITH HEAD

  1. A337437
    Using a 6 mm hexagon wrench, remove the 4 No. 1 straight screw plug with heads from the cylinder head sub-assembly.


7. REMOVE STUD BOLT

NOTICE:
If a stud bolt is deformed or its threads are damaged, replace it.

← COMPONENTS (from Jan 2017)INSPECTION (from Jan 2017) →