2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR

  1. A329093E06
    Using a 14 mm union nut wrench, install the No. 4 exhaust gas temperature sensor to the front exhaust pipe assembly.

    Torque:
    Specified tightening torque
    30 N*m {306 kgf*cm, 22 ft.*lbf}

    Text in Illustration 
    *a
    Torque Wrench Fulcrum Length

    NOTICE:
    If the No. 4 exhaust gas temperature sensor is dropped, replace it with a new.

    HINT:
    1. Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (Click here).
    2. When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26 N*m (268 kgf*cm, 19 ft.*lbf)

  1. Connect the connector to the No. 4 exhaust gas temperature sensor.

← INSPECTION (from Jan 2017)COMPONENTS (from Jan 2017) →