Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2019.02–2019.06
BM35X0E _V1 General _080416 INTRODUCTION _0389976 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Note
ECM
for 7GR-FKS:

Perform Vehicle Identification Number (VIN) or frame number registration


DTC P063051 is stored -
for 1GD-FTV:

Perform Vehicle Identification Number (VIN) or frame number registration


DTC P063051 is stored -
ECU communication ID registration Engine start function See Service Bulletin for the registration method.
for RC60J:

Performing iMT installation information reset


·

iMT system

·

DTCs are output


-
for 7GR-FKS:
·

Throttle body with motor assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Fuel injector assembly (for port injection)

·

Fuel injector assembly (for direct injection)

·

Fuel pump (for low pressure side)

·

Fuel pump assembly (for high pressure side)

·

Fuel pressure sensor (for low pressure side)

·

Fuel pressure sensor (for high pressure side)

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


-
for 1GD-FTV:

Engine assembly


Clear crank time compensation data Engine starting -
·

Input injector compensation code

·

Pilot quantity learning


Engine starting -
for 1GD-FTV:

Crankshaft position sensor plate


Clear crank time compensation data Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data -
for 1GD-FTV(w/ DPF), 1GD-FTV(w/ Urea SCR System):

Air fuel ratio sensor


Clear A/F sensor learning value data - -
for 1GD-FTV(w/ DPF), 1GD-FTV(w/ Urea SCR System):

Exhaust manifold converter sub-assembly


Clear DPF thermal deterioration data - -
for 1GD-FTV:

Injector assembly


·

Input injector compensation code

·

Pilot quantity learning


Engine starting -
for 1GD-FTV:
·

Diesel throttle body assembly

·

Electric EGR control valve assembly

·

Turbocharger nozzle vane control actuator


Perform initialization - -
·

Forward recognition camera

·

Windshield glass (Including removal and installation)


Adjust forward recognition camera
·

Front camera system

·

Lane control system

·

Road sign assist system

·

Front radar sensor system

·

Pre-collision system

·

Automatic high beam system


-
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Lane control system

·

Road sign assist system

·

Front radar sensor system

·

Pre-collision system

·

Automatic high beam system


-
Engine stop and start ECU
·

Download the engine stop and start ECU data

·

Write the engine stop and start ECU data to the new engine stop and start ECU

·

Check electromagnetic oil pump (for automatic transmission)

·

Reset air conditioning information

·

Learning air conditioning information

·

Clear the zero point calibration data

·

Deceleration sensor zero point calibration


Stop and start system -
w/ Stop and Start System:

Air conditioning amplifier assembly


·

Reset air conditioning information

·

Learning air conditioning information


w/ Stop and Start System:

Starter assembly

NOTICE:

When the starter assembly is replaced, "STARTER relay" and "STARTER NO.2 relay" must be also replaced.



Clear the number of starter operations
w/ Stop and Start System:
·

Flywheel sub-assembly (for Automatic Transmission)

·

Flywheel with damper assembly (for Manual Transmission)


Total number of engine starts reset
for AC60E, w/ Stop and Start System:

Electromagnetic oil pump


Check electromagnetic oil pump
Airbag sensor assembly
·

Clear the zero point calibration data

·

Deceleration sensor zero point calibration


Stop and start system -
w/ VSC OFF Switch:
·

Perform reset memory

·

Perform acceleration sensor zero point calibration and store system information memorization


·

VSC is disabled or malfunctions

·

DTCs are output

·

Slip indicator light illuminates

·

ABS warning light illuminates


-
for AE60E:
·

Automatic transmission assembly

·

Transmission valve body assembly

·

Any of the shift solenoid valve


Reset memory
·

Large shift shock

·

Engine overruns


-
for AE60E:

Automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
·

Tire pressure warning ECU and receiver

·

Tire pressure warning valve and transmitter


·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates

·

Tire pressure warning function


-
Skid control ECU (brake actuator assembly)
w/ VSC OFF Switch:

Perform acceleration sensor zero point calibration and store system information


·

VSC is disabled or malfunctions

·

DTCs are output

·

Slip indicator light illuminates

·

ABS warning light illuminates


-
w/o VSC OFF Switch:

Store system information


·

VSC is disabled or malfunctions

·

DTCs are output

·

ABS warning light illuminates


-
Telephone transceiver assembly Register vehicle information Emergency call service -
Mobilephone battery Reset mobilephone battery condition
Steering sensor (Including removal and installation) Steering angle neutral point Parking assist monitor system -
Steering angle setting Parking assist monitor system -
Suspension, tires, etc. Television camera assembly optical axis (Back camera position setting) Parking assist monitor system -
Television camera assembly Parking assist monitor system initialization Parking assist monitor system -
Television camera assembly (Only for removal and installation) Television camera assembly optical axis (Back camera position setting) Parking assist monitor system -
Blind spot monitor sensor Blind spot monitor beam axis adjustment Blind spot monitor system -
·

Door control transmitter assembly

·

Transponder key ECU assembly


Code registration Engine start function See Service Bulletin for the registration method.
·

Door control transmitter module set sub-assembly

·

Door control receiver


Register a new recognition code Wireless door lock control system -
for Automatic Air Conditioning System:
·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 1 blower damper servo sub-assembly

·

Air conditioning amplifier assembly


Servo motor initialization DTCs are output -
·

Power window regulator motor assembly LH

·

Power window regulator motor assembly RH

·

Front door window regulator assembly LH

·

Front door window regulator assembly RH

·

Front door glass sub-assembly LH

·

Front door glass sub-assembly RH

·

Front door glass run LH

·

Front door glass run RH


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function


-
Slide door motor unit Reset slide door close position Power slide door system -