REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
| *A | w/o ROOF PANEL REINFORCE STIFFENER NO.2 | - | - |
| *A | w/ ROOF PANEL REINFORCE STIFFENER NO.2 | - | - |
| *1 | ROOF PANEL REINFORCE STIFFENER NO.2 | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Spot Weld |
|
Plug Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Before temporarily installing the new parts, apply body sealer to the roof panel reinforcement sub-assembly No.1.
Apply enough body sealer to the panels.
| *1 | ROOF PANEL REINFORCEMENT SUB-ASSEMBLY NO.1 | - | - |
Before temporarily installing the new parts, weld the roof panel front and roof panel reinforcement sub-assembly No.1 with the standard number of welding points.
| *1 | ROOF PANEL FRONT | *2 | ROOF PANEL REINFORCEMENT SUB-ASSEMBLY NO.1 |
Before temporarily installing the new parts, apply body sealer to the windshield header panel and roof panel reinforcement No.1.
Apply enough body sealer to the panels.
| *1 | WINDSHIELD HEADER PANEL | *2 | ROOF PANEL REINFORCEMENT NO.1 |
Weld the roof panel front to the vehicle side.
| *A | w/o ROOF PANEL REINFORCE STIFFENER NO.2 | - | - |
| *1 | ROOF PANEL FRONT | - | - |
| *A | w/ ROOF PANEL REINFORCE STIFFENER NO.2 | - | - |
| *1 | ROOF PANEL FRONT | *2 | ROOF PANEL REINFORCE STIFFENER NO.2 |
After welding, apply the foamed sealing material to the corresponding parts. (See the painting/coating)
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 1016 mm (40.00 in.) | B | 1222 mm (48.11 in.) |
| C | 519 mm (20.43 in.) | - | - |