With the quarter panel cut and join replacement sections removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.
|
Adhesive | - | - |
| *A | for Type A | - | - |
| *A | for Type B | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Spot Weld |
|
Plug Weld |
|
Assembly Mark |
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).
Do not apply adhesive around the plug welding points.
Minimize squeeze out in plug welding areas.
|
Adhesive | - | - |
For positioning of the new parts, align the installation standard holes of the outer panel and the inner panel.
| *A | for Type A | - | - |
| *1 | QUARTER WHEEL HOUSE PANEL OUTER | - | - |
| *A | for Type B | - | - |
| *1 | QUARTER WHEEL HOUSE PANEL OUTER | - | - |
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.