Point E,e, Q,q, and S,s on the vehicle are asymmetrical.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A | Dash Panel Center Mark | - |
| B, b | Hood Hinge Installation Nut | M8 (0.31) |
| C, c | Body Repair Hole | φ5 (0.20) |
| D, d | Radiator Upper Support Standard Hole | φ10 (0.39) |
| E, e | Radiator Upper Support Standard Hole | φ10 (0.39) |
| F, f | Radiator Support Installation Nut | M8 (0.31) |
| G, g | Radiator Support Installation Nut | M8 (0.31) |
| H, h | Radiator Support Standard Hole | φ10 (0.39) |
| J, j | Front Crossmember No1 Reinforcement Standard Hole | φ10 (0.39) |
| K, k | Front Bumper Reinforcement Installation Nut | M10 (0.39) |
| L, l | Front Bumper Reinforcement Installation Nut | M10 (0.39) |
| M | Center Brace Installation Nut | M6 (0.24) |
| N, n | Front Fender Extension Standard Hole | φ10 (0.39) |
| O, o | Front Suspension Installation Hole (Upper Face) | φ12.3 (0.48) |
| P, p | Air Conditioning drain Installation Nut | M6 (0.24) |
| Q, q | Front Side Member No1 Standard Hole | φ13 (0.51) |
| R, r | Front Suspension Installation Hole (Lower Face) | φ12.3 (0.48) |
| S, s | Front Fender Apron Extension Standard Hole | φ10 (0.39) |
|
Symmetric distance |
|
Asymmetric distance |
| *a | mm
(in.) |
- | - |
| *W | Width distance | *L | Length distance |
| *X | Diagonal distance | - | - |
| *a | mm
(in.) |
*b | LH |
| *c | RH | - | - |
| *W | Width distance | *L | Length distance |
| *X | Diagonal distance | - | - |
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A | Dash Panel Center Mark | - |
| B, b | Hood Hinge Installation Nut | M8 (0.31) |
| C, c | Front Fender Installation Nut | M6 (0.24) |
| D, d | Headlight Installation Hole | 9X9
(0.35X0.35) |
| E, e | Radiator Support Installation Nut | M8 (0.31) |
| F, f | Radiator Support Installation Nut | M8 (0.31) |
| G | Center Brace Installation Nut | M6 (0.24) |
| H, h | Headlight Mounting Standard Hole | φ6 (0.24) |
| J, j | Front Fender Installation Nut | M6 (0.24) |
| K, k | Front Fender Installation Nut | M6 (0.24) |
| *a | mm
(in.) |
- | - |
| *W | Width distance | *L | Length distance |
| *X | Diagonal distance | - | - |