Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Front Suspension Cross Member Lower Standard Hole | φ15 (0.59) |
| B, b | Front Suspension Installation Hole | φ24 (0.94) |
| C, c | Front Suspension Installation Hole | φ23.7 (0.93) |
| D, d | Front Lower arm Installation Hole | φ18.5 (0.73) |
| E, e | Suspension Member Brace Installation Nut | M10 (0.39) |
| F, f | Front Lower arm Installation Hole | φ20 (0.79) |
| G, g | Front Suspension Installation Hole | φ24 (0.94) |
| *a | mm
(in.) |
- | - |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm
(in.) |
- | - |