REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut Location for Supply Parts |
| *A | for Type A | - | - |
| *A | for Type B | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Before temporarily installing the new parts, apply body sealer to the roof panel reinforcement sub-assembly No.7.
Apply enough body sealer to the panels.
| *1 | ROOF PANEL REINFORCEMENT SUB-ASSEMBLY NO.7 | - | - |
Before temporarily installing the new parts, weld the roof panel rear No.3 and roof panel reinforcement sub-assembly No.7 with the standard number of welding points.
| *1 | ROOF PANEL REAR NO.3 | *2 | ROOF PANEL REINFORCEMENT SUB-ASSEMBLY NO.7 |
Before temporarily installing the new parts, apply body sealer to the roof panel reinforcement No.8.
Apply enough body sealer to the panels.
| *1 | ROOF PANEL REINFORCEMENT NO.8 | - | - |
Weld the roof panel rear No.3 to the vehicle side.
| *A | for Type A | - | - |
| *1 | ROOF PANEL REAR NO.3 | - | - |
| *A | for Type B | - | - |
| *1 | ROOF PANEL REAR NO.3 | - | - |
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 971 mm (38.23 in.) | B | 1417 mm (55.79 in.) |
| C | 1414 mm (55.67 in.) | D | 945 mm (37.20 in.) |
| E | 944 mm (37.17 in.) | - | - |