REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut and Join Location |
| *a | 60 mm (2.36 in.) | - | - |
| *a | 15 mm (0.59 in.) | - | - |
| *a | 10 mm (0.39 in.) | *b | 20 mm (0.79 in.) |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
|
Butt Weld |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
| *1 | REAR FLOOR REAR CROSS MEMBER SUB-ASSEMBLY OUTER | *2 | REAR BUMPER COVER BRACKET |
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.