Home › Vehicle Exterior › BODY PANEL › REAR FLOOR SIDE PANEL EXTENSION (except Wagon) › from 2019.06
BM35X0E _01 Vehicle Exterior _080418 BODY PANEL _0400317 REAR FLOOR SIDE PANEL EXTENSION(except Wagon) F

BODY PANEL  REAR FLOOR SIDE PANEL EXTENSION(except Wagon)  ASSEMBLY REPLACEMENT  


K151927

With the quarter panel cut and join replacement sections removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108819

Remove Weld Points
K108820

Remove Weld Points

a.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.


K151065C01
0,0 0,0 false
K108837

Adhesive - -


K151063

K151064



INSTALLATION


Symbol Meaning
K108821

Spot Weld
K108823

Plug Weld
K108824

Plug Weld
K108825

Plug Weld

a.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).

HINT:
·

Do not apply adhesive around the plug welding points.

·

Minimize squeeze out in plug welding areas.



K151065C02
0,0 0,0 false
K108837

Adhesive - -


K151106C01
1.26,1.24 1.021,0.5 1.021,0.5 1.188,0.5 false 1.25,0.427 1.563,0.583 0.313,0.156 10 false *1
*1 FLOOR SIDE RAIL SUB-ASSEMBLY REAR - -


K151107


b.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)


c.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.