With the rear floor lower rear crossmember assembly and rear floor side panel extension assembly removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut and Join Location |
Remove the A.
| *A | except Space Up Seat | - | - |
Carefully cut the A so as not to damage B.
| *a | 60 mm (2.36 in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Plug Weld |
|
Butt Weld |
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Remove A from the new parts.
A is reused.
| *A | except Space Up Seat | ||
| *1 | REAR SIDE MEMBER SUB-ASSEMBLY | - | - |
Weld the A to the vehicle side.
Weld the A to the vehicle side.
| *A | except Space Up Seat | - | - |
After welding, apply undercoating to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.