Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2019.02–2019.06
NM35X0E _57 Power Source / Network _078502 NETWORKING _0381309 CAN COMMUNICATION SYSTEM CO CONTROL F

NETWORKING  CAN COMMUNICATION SYSTEM  CONTROL  CAN COMMUNICATION CONTROL  


FUNCTION


CAN Connection Components

*1: Models with SRS airbag system

*2: Models with blind spot monitor system

*3: Models with Toyota Safety Sense

*4: Models with Toyota parking assist-sensor system

*5: Models without VSC

*6: Models with DCM

*7: Models with power slide door system (LH Side)

*8: Models with power slide door system (RH Side)

*9: Models with stop and start system

*10: Models with UREA SCR System

*11: Models with VFC power steering

*12: Models with multimedia system or navigation system

*13: Models with parking assist monitor system

*14: Models with VSC

Air Conditioning Amplifier Assembly Airbag ECU (Airbag Sensor Assembly)*1
Blind Spot Monitor Sensor LH*2 Blind Spot Monitor Sensor RH*2
Forward Recognition Camera*3 Central Gateway ECU (Network Gateway ECU)
Clearance Warning ECU Assembly*4 Combination Meter Assembly
Combination Switch ECU Sub-assembly*5 DCM (Telephone Transceiver Assembly)*6
Slide Door ECU (LH)*7 Slide Door ECU (RH)*8
ECM Engine Stop and Start ECU*9
Main Body ECU (Multiplex Network Body ECU) Millimeter Wave Radar Sensor Assembly*3
Nitrogen Oxides Sensor*10 Power Steering ECU Assembly*11
Radio and Display Receiver Assembly*12 Rear Television Camera Assembly*13
Skid Control ECU Steering Sensor*14
UREA Pump Control ECU*10 -


DIAGNOSIS


a.

If a malfunction occurs on a CAN communication bus, ECUs that are connected to the CAN communication bus store Diagnostic Trouble Codes (DTCs) in memory.


b.

The 5-digit DTCs can be read by connecting the Global TechStream (GTS) to the DLC3.


c.

For details, refer to the Repair Manual.