CONSTRUCTION
Rear Cooling Unit Assembly (Models with Manual Rear Cooler System)
The rear cooling unit consists of the evaporator sub-assembly (rear), rear evaporator fin sensor (No. 2 cooler thermistor), rear blower motor with fan sub-assembly, rear cooler blower resistor*1 and blower motor control*2.
A Beneficial Refrigerant Stream (BRS) type evaporator is used.
*1: DX grade
*2: GL grade
| *1 | Rear Cooling Unit Assembly | - | - |
| *a | The illustration shown is an example only. | - | - |
| *1 | Roof Air Duct (No. 1 Cooler Air Duct) | - | - |
| *1 | Front Roof Air Duct (No. 1 Cooler Air Duct) | *2 | Center Roof Air Duct (No. 1 Cooler Air Duct) |
| *3 | Rear Roof Air Duct (No. 1 Cooler Air Duct) | - | - |
| *1 | Front Roof Air Duct (No. 1 Cooler Air Duct) | *2 | Center Roof Air Duct (No. 1 Cooler Air Duct) |
| *3 | Rear Roof Air Duct (No. 1 Cooler Air Duct) | - | - |
Rear Heater Unit (Heater Assembly) (Models with Manual Rear Heater System)
The rear heater unit consists of the rear heater unit sub-assembly, rear blower motor sub-assembly and rear heater blower resistor.
A Straight Flow Aluminum-II (SFA-II) heater core that is compact and offers advanced performance is used.
| *1 | Rear Heater Assembly | - | - |
| *1 | Rear Heater Assembly | - | - |
OPERATION
Rear Cooling Unit Assembly (Models with Manual Rear Cooler System)
Air Outlets and Airflow Volume (Standard Roof Models)
Air Outlets and Airflow Volume (High Roof Models with Roof Window Glass)
Air Outlets and Airflow Volume (High Roof Models without Roof Window Glass)