OUTLINE
A dry type single plate clutch, which is operated by hydraulic pressure, is used.
A resin clutch master cylinder is used.
A clutch accumulator assembly is used.
A clutch pedal turnover spring is used.
A Light-Pedal Effort Clutch (L-PEC) type clutch cover is used on models with a 1GD-FTV Engine.
The clutch start system is used to help enhance safety.
A dual mass flywheel (DMF) is used on models with a 1GD-FTV engine.
SPECIFICATION
Models with 7GR-FKS Engine
| Clutch | Type | Single Dry Plate, Diaphragm |
| Operation | Hydraulic | |
| Clutch Cover | Type | Conventional |
| Installed Load | 8350 N | |
| Clutch Disc | Facing Size* | 275.0 mm x 175.0 mm (10.8 in. x 6.9 in.) |
| Master Cylinder | Type | Plunger |
| Cylinder Diameter | 19.05 mm (0.75 in.) | |
| Release Cylinder | Type | Conventional |
| Cylinder Diameter | 19.05 mm (0.75 in.) | |
| Clutch Pedal | With clutch pedal stroke sensor*2 | |
*1: Outer diameter x inner diameter
*2: Models with iMT Switch
Models with 1GD-FTV Engine
| Clutch | Type | Single Dry Plate, Diaphragm |
| Operation | Hydraulic | |
| Clutch Cover | Type | L-PEC |
| Installed Load | 9300 N | |
| Clutch Disc | Facing Size*1 | 275.0 mm x 175.0 mm (10.8 in. x 6.9 in.) |
| Master Cylinder | Type | Plunger |
| Cylinder Diameter | 19.05 mm (0.75 in.) | |
| Release Cylinder | Type | Conventional |
| Cylinder Diameter | 22.2 mm (0.87 in.) | |
| Clutch Pedal | With clutch pedal stroke sensor*2 | |
*1: Outer diameter x inner diameter
*2: Models with iMT Switch
MAIN FEATURES
L-PEC Type Clutch Cover
This type of clutch cover reduces the increase in necessary pedal effort caused by the clutch disc becoming worn.