FUNCTION
The ETCS-i, which provides excellent throttle control in all operating ranges, is used.
The ETCS-i uses the ECM to calculate the optimal throttle valve opening angle that is appropriate for the respective driving conditions and uses a throttle control motor to control the throttle valve opening angle.
The ETCS-i controls the idle speed and cruise control system.
The throttle position sensor employs a dual-circuit system to reinforce the fail-safe function, thereby ensuring reliability.
|
*1: Models with cruise control system *2: Models with VSC |
|
| Throttle Valve Opening Angle Control | Controls the throttle valve opening angle in accordance with the driving conditions based on signals from the ECM. |
| Idle Speed Control (ISC) | Controls the fast idle speed in accordance with the engine coolant temperature, rotation fluctuation control during engine load, etc., to regularly maintain the optimal idle speed. |
| ECT + EFI + ETCS-i Integrated Control (Shift Shock Reduction Control) | Controls the throttle valve opening angle during ECT shifting to achieve a reduction in shift shock when shifting up and down and to reduce the shifting time. |
| VVT-i + VVT-iW + ETCS-i Integrated Control | Cooperatively controls the throttle valve, VVT-iW and VVT-i to achieve optimal fuel economy during normal driving. Also, controls each actuator in accordance with the driver's intentions during acceleration to achieve a high torque response. |
| Cruise Control*1 | The ECM actuates the throttle valve for the operation of the cruise control. |
| TRC Throttle Control*2 | As part of the TRC, the throttle valve opening angle is reduced by a demand signal sent from the skid control ECU to the ECM. This demand signal is sent if an excessive amount of slippage occurs at a drive wheel, ensuring vehicle stability and applying an appropriate amount of power to the road. |
| VSC Coordination Control*2 | In order to bring the effectiveness of the VSC into full play, the throttle valve angle is regulated through a coordination control by the skid control ECU and the ECM. |