CONSTRUCTION
By integrating the exhaust manifold into the cylinder head sub-assembly, the exhaust gas can be cooled using the water jacket of the cylinder head sub-assembly. This results in enhanced drivability and fuel economy and a reduction of unburned gasoline due to the stoichiometric ratio being closer to ideal.
The shape and location of the water jackets have been optimized to provide space for larger exhaust ports.
The cylinder head sub-assembly has been simplified by separating the camshaft housing (cam journal portion) from the cylinder head sub-assembly.
A taper squish combustion chamber is used to improve anti-knock performance and intake efficiency. In addition, engine performance and fuel economy are improved.
A siamese type intake port is used. The port diameter gradually decreases toward the combustion chamber to optimize the airflow speed and intake pulsation.
An air injection port, which directs the air from the air pump assembly to the exhaust port of each cylinder, has been provided on top of the exhaust port.*
*: Models with secondary air injection system
| *1 | Camshaft Bearing Cap | *2 | Camshaft Housing Sub-assembly RH |
| *3 | Camshaft Housing Sub-assembly LH | *4 | Cylinder Head Sub-assembly |
| *5 | Cylinder Head LH | *6 | Intake Valve |
| *7 | Exhaust Valve | - | - |
| *a | Intake Side | *b | Exhaust Side |
| *c | Taper Squish Area | *d | View from Bottom |
| *e | Spark Plug Hole | *f | Upright Intake Port |
| *g | A-A Cross Section | - | - |
| *1 | Camshaft Bearing Cap | *2 | Camshaft Housing Sub-assembly RH |
| *3 | Camshaft Housing Sub-assembly LH | *4 | Cylinder Head Sub-assembly |
| *5 | Cylinder Head LH | *6 | Intake Valve |
| *7 | Exhaust Valve | - | - |
| *a | Intake Side | *b | Exhaust Side |
| *c | Taper Squish Area | *d | View from Bottom |
| *e | Spark Plug Hole | *f | Upright Intake Port |
| *g | A-A Cross Section | - | - |
| *a | Exhaust Manifold Built into Cylinder Head (Exhaust Port) | - | - |
| *a | Exhaust Manifold Built into Cylinder Head (Exhaust Port) | *b | Air Injection Port |
| *a | Siamese Type | *b | Independent Type |
The difference between a siamese type intake port and an independent type one is shown in the illustration.