CONSTRUCTION
A resin cylinder head cover sub-assembly is used. Ribs are positioned on the cylinder head cover sub-assembly to achieve weight reduction while improving rigidity and quietness.*1
The resin baffle plate, oil delivery pipe and ejector are welded onto the cylinder head cover sub-assembly to reduce the number of parts.*1
An aluminum cylinder head cover is used. As a result, rigidity is ensured and NV performance is improved.*2
An oil delivery pipe is installed inside each cylinder head cover sub-assembly. This ensures lubrication to the sliding parts of the No. 1 valve rocker arm sub-assemblies, improving reliability.
*1: Models without secondary air injection system
*2: Models with secondary air injection system
| *1 | Cylinder Head Cover Sub-assembly | *2 | Cylinder Head Cover Gasket |
| *3 | Cylinder Head Cover Sub-assembly LH | *4 | Cylinder Head Cover Gasket LH |
| *a | Oil Delivery Pipe | - | - |
| *1 | Cylinder Head Cover Sub-assembly | *2 | Cylinder Head Cover Gasket |
| *3 | Cylinder Head Cover Sub-assembly LH | *4 | Cylinder Head Cover Gasket LH |
| *a | Oil Delivery Pipe | - | - |