CONSTRUCTION
A forged iron fuel delivery pipe assembly (for direction injection) is used.
A fuel pressure sensor (for high pressure) is installed to the fuel delivery pipe assembly (for direct injection).
A nozzle holder clamp is used for the installation area of the direct fuel injector assembly. The nozzle holder clamp constantly pushes the direct fuel injector assembly by the force of the spring to prevent the direct fuel injector assembly from moving when fuel pressure is applied to the direct fuel injector assembly while starting the engine with low fuel pressure. As a result, vibration and noise are reduced while at the same time airtightness is increased.
A metal touch taper seal is used for the fuel pressure sensor (for high pressure) and fuel pipe (for high pressure) fastener.
| *1 | Fuel Delivery Pipe RH (for Direct Injection) | *2 | Fuel Delivery Pipe with Sensor Assembly LH (for Direct Injection) |
| *3 | Nozzle Holder Clamp | *4 | Direct Fuel Injector Assembly |
| *5 | Fuel Pressure Sensor (for High Pressure) | *6 | No. 2 Fuel Pipe Sub-assembly (for High Pressure) |
| *7 | No. 1 Fuel Pipe Sub-assembly (for High Pressure) | - | - |