FUNCTION OF MAIN COMPONENTS
The main components of the secondary air injection system are as follows:
| Component | Function | |
|---|---|---|
| Air Pump Assembly | Uses a built-in DC motor to supply air to the emission control valve set. | |
| Emission Control Valve Set | Air Switching Valve | Introduces air that is pumped by the air pump into the exhaust manifold. |
| Air Pressure Sensor | Detects the air injection pressure. | |
| Air Injection Control Driver | ·
Activated by the ECM, the air injection control driver actuates the air pump assembly and the emission control valve set. ·
Detects an input-output circuit failure at the air injection control driver and transmits it to the ECM. |
|
| ECM | ·
Controls the secondary air injection system in accordance with signals from the crankshaft position sensor, E.F.I. engine coolant temperature sensor, mass air flow meter sub-assembly and air pressure sensor. ·
Receives a failure detection signal from the air injection control driver and stores a corresponding DTC in memory. |
|
FUNCTION
To ensure the proper warm-up performance of the Three-Way Catalytic converters (TWCs) after starting a cold engine, an secondary air injection system is used.
This system is comprised of an air injection control driver, an air pump assembly, and 2 emission control valve sets with built-in air pressure sensors.
The emission control valve sets provided on each bank are controlled independently by the ECM and the air injection control driver.
The ECM estimates the amount of air injected to the TWCs based on signals from the mass air flow meter sub-assembly in order to regulate the air injection timing.