CONSTRUCTION
The emission control valve set consists of an air switching valve that switches the air flow and a reed valve that restricts the exhaust flow to one direction.
The air switching valve is a solenoid valve that is actuated by the ECM and air injection control driver.
The emission control valve sets for bank 1 and bank 2 have the same basic structure and function.
The air pressure sensor is built into the corresponding emission control valve set.
The air pressure sensor consists of a semiconductor which utilizes the characteristics of a silicon chip that changes its electrical resistance when pressure is applied to it. The sensor converts the air injection pressure into an electrical signal, and sends it to the ECM in an amplified form.
When the air switching valve turns on, an air injection pipe, which is provided in the exhaust manifold, directs the air from the air pump assembly to the exhaust port.
| *1 | No. 1 Emission Control Valve Set | *2 | No. 2 Emission Control Valve Set |
| *a | No. 1 Emission Control Valve Set Cross Section | *b | Air Pressure Sensor |
| *c | Air Switching Valve | - | - |
|
Air In |
|
Air Out |