FUNCTION OF MAIN COMPONENTS
| Component | Function | |
|---|---|---|
| Back Door Lock with Courtesy Light Switch Assembly | Back Door Closer Motor | Latches and unlatches the back door when actuated by the back door closer ECU. |
| Initial Position Switch | Detects the initial position of the back door closer motor and outputs a signal to the back door closer ECU. | |
| Half/Full Latch Switch | Detects whether the ratchet condition is released or engaged and outputs a signal to the back door closer ECU. | |
| Courtesy Switch | Detects whether the back door is ajar or fully closed and outputs a signal to the back door closer ECU. | |
| Back Door Closer ECU (Back Door Closer Relay) | Controls the back door closer system in accordance with the signals received from the switches and sensors. | |
SYSTEM CONTROL
Close Operation
Closing the back door to the half-shut, starts a closing operation.
When the back door is moved to the ajar position, the ECU performs a close operating according to signals from each switch.
| [T] | Component | Operation | Outline |
|---|---|---|---|
| (a) | Back door condition changes from open to ajar. | ||
| Half/Full Latch Switch | Changes from On to Off | The door is detected to be ajar. | |
| (b) | Back Door Closer Motor | Changes from Off to Engagement Rotation | When an ajar condition is detected, the engagement rotation relay turns on and an engagement rotation operation starts. |
| (c) | Initial Position Switch | Changes from Off to On | The back door closer motor and back door lock drive gear initial position detection is turned on. |
| (d) | Courtesy Switch | Changes from On to Off | The door is detected to be fully closed. |
| (e) | Half/Full Latch Switch | Changes from Off to On | The full latch condition is detected. |
| Back Door Closer Motor | Changes from Engagement Rotation to Off | When the full latch condition is detected, the engagement rotation relay turns off and the engagement rotation operations stops. | |
| (f) | Back Door Closer Motor | Changes from Off to Release Rotation | Approximately 0.1 seconds after the back door closer motor is detected to be off, the release rotation relay turns on and a release rotation operation starts in order to return the back door closer motor and back door lock drive gear to the initial position. |
| (g) | Initial Position Switch | Changes from On to Off | The back door closer motor and back door lock drive gear initial position is detected. |
| Back Door Closer Motor | Changes from Release Rotation to Off | When the original position switch is detected to be on, the release rotation relay turns off and the release rotation operation stops. | |