CONSTRUCTION
A urea pump is used, and is positioned in the bottom of the urea tank sub-assembly.
| *1 | Float Sensor | *2 | Filter |
| *3 | Pump Motor | *4 | Heater |
The urea pump has the following functions:
| Function | Outline |
|---|---|
| Pump Function | While performing feedback control according to the pressure sensor inside the urea pump, the pump raises the pressure to approximately 500 kPa, sending urea solution to the urea injector set. |
| Heating Function | The heater inside the urea pump is operated to thaw the urea solution so that exhaust gas can be purified even when the ambient temperature is low and the urea solution freezes. The heater turns on and off according to the urea solution temperature sensor inside the urea pump. |
| Filter Function | Foreign matter that enters the urea tank sub-assembly is collected by the filter inside the urea pump, preventing foreign matter from getting jammed in the urea pump and urea injector set. |
| Level Gauge Function | The fluid level position is detected by the float sensor inside the urea pump in order to detect the remaining quantity of urea solution inside the urea tank sub-assembly. |