Home › Vehicle Interior › MIRROR (INT) › DIGITAL REAR-VIEW MIRROR SYSTEM
NM35X0E _58 Vehicle Interior _078532 MIRROR (INT) _0390214 DIGITAL REAR-VIEW MIRROR SYSTEM CO CONTROL F

MIRROR (INT)  DIGITAL REAR-VIEW MIRROR SYSTEM  CONTROL  CAMERA CLEANER CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Outline

*1: Models without rear washer system

*2: Models with rear washer system

*3: Models with VSC

*4: Models without VSC

Windshield Wiper Switch Assembly
·

Camera Cleaner Switch*1

·

Rear Washer Switch*2


Operates the camera cleaner system and sprays washer fluid on the surface of the camera lens according to camera cleaner switch*1 or rear washer switch*2 operation.
Inner Mirror Camera Assembly Captures images of areas to the rear of the vehicle and outputs them as video signals.
Steering Sensor*3 Receives camera cleaner switch*1 or rear washer switch*2 operation signals from the windshield wiper switch assembly and sends them to the main body ECU via the central gateway ECU.
Combination Switch ECU Sub-assembly*4
Central Gateway ECU (Network Gateway ECU) Relays the signal between the CAN communication lines.
Main Body ECU (Multiplex Network Body ECU) Sends windshield washer motor and pump assembly operation signals based on camera cleaner switch*1 or rear washer switch*2 operation signals.
Windshield Wiper Relay Assembly Receives operation signals from the main body ECU and operates the windshield washer motor and pump assembly.
Windshield Washer Motor and Pump Assembly Operates according to windshield wiper relay assembly signals and sprays washer fluid from the camera washer.


SYSTEM CONTROL


a.

For models without the rear washer system, when the camera cleaner switch is operated, the camera cleaner system operates.


b.

For models with the rear washer system, when the rear washer switch is operated, the camera cleaner system operates linked with the rear wiper washer.



OPERATING CONDITION


a.

Camera Cleaner System Operation and Cancel Conditions

i.

The camera cleaner system operates when all of the following conditions are met.

·

The ignition switch is turned to ON.

·

The camera cleaner switch*1 or rear washer switch*2 is operated.



ii.

The camera cleaner system stops operating when either of the following conditions is met.

·

The ignition switch is turned from ON to ACC or off.

·

The camera cleaner switch*1 or rear washer switch*2 operation is stopped.


*1: Models without rear washer system

*2: Models with rear washer system