CONSTRUCTION
Anti-corrosion Sheet Steel
Anti-corrosion sheet steel is used as in the following illustration:
| *a | Anti-corrosion Sheet Steel | - | - |
| *a | Anti-corrosion Sheet Steel | - | - |
Anti-chipping Application and Rust-resistant Performance
Wax is applied to the edge of the door lower portion, door hinge, fuel filler lid hinge, and the hemmed portions of the hood panel and back door panel sub-assembly to improve rust-resistant performance.
| *1 | Hood Sub-assembly | *2 | Fuel Filler Opening Lid Assembly |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
| *e | E - E Cross Section | *f | F - F Cross Section |
| *g | Body Wax | *h | Lid Hinge Wax |
| *i | Stone Guard Coat | - | - |
| *1 | Back Door Hinge Assembly LH | *2 | Back Door Hinge Assembly RH |
| *3 | Slide Door Hinge Assembly Center RH | *4 | Front Door Hinge Assembly Upper RH |
| *5 | Front Door Hinge Assembly Lower RH | - | - |
| *a | Wax | - | - |
Polyvinyl Chloride (PVC) coating is applied to the wheel housings, and other parts that are located where they are susceptible to stone chipping damage, improving the rust-resistance of these areas.
| *a | Edge Seal | *b | Under Coating Area |
| *c | Except Models with Rear Wheel House Liner | - | - |
| *a | Edge Seal | *b | Under Coating Area |
| *c | Models for Russia | *d | Except Models with Rear Wheel House Liner |
To protect the paint of outer panels from small rocks and fragments that have been kicked up from the road surface, transparent anti-chip tape is provided depending on the model.
| *1 | Quarter Panel Protector Front RH | *2 | Rear Wheel Extension Protector RH |