Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › from 2019.06
NM35X0E _58 Vehicle Interior _078344 LIGHTING (INT) _0379916 LIGHTING SYSTEM CO CONTROL F

LIGHTING (INT)  LIGHTING SYSTEM  CONTROL  LIGHT CONTROL  


FUNCTION


a.

The illuminated entry system has the following functions:

Models without Back Door Inside Handle Light (Van Models or Commuter Models)
Function Outline Lights that Operate

*1: Models with immobiliser system

*2: Models with slide door step light

*3: Models with slide door scuff illumination light

*4: Models without immobiliser system

*5: Models with room light switch

Door Lock/Unlock-linked
·

When any door is unlocked, the lights that operate turn on.

·

When all doors are locked, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assemblies

·

Ignition Key Illumination Light*1


Door Open/Close-linked
·

When front door or back door is opened, the lights that operate turn on.

·

When all doors are closed, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assemblies

·

Ignition Key Illumination Light*1


·

When rear door is opened, the lights that operate turn on.

·

When all doors are closed, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assemblies

·

Ignition Key Illumination Light*1

·

Slide Door Step Light*2

·

Slide Door Scuff Illumination Light*3


·

When driver side front door is opened, the lights that operate turn on.

·

When driver side front door is closed, the lights that operate turn off.


·

Key Cylinder Light Assembly*4


Power Source-linked
·

When the ignition switch is turned from ACC or ON to off, the lights that operate turn on.

·

When the ignition switch is turned from off to ACC or ON, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assemblies

·

Ignition Key Illumination Light*1


Delay When approximately 15 seconds elapse after any of the following conditions is met, the lights that operate turn off:
·

A door unlock-linked function is operated.

·

Any door is opened and then all doors are closed when the ignition switch is off.

·

The ignition switch is turned from ACC or ON to off when all the doors are closed.


·

Map Lights

·

No. 1 Room Light Assemblies

·

Ignition Key Illumination Light*1


Room Light Switch *5
·

When the room light switch is turned to on, the lights that operate turn on.

·

When the room light switch is turned to off, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assemblies


Battery Saving
·

When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.

·

The battery saving function is canceled when any of the following operations is performed before the lights are turned off by the function. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.

-

The ignition switch is turned to ACC or ON.

-

Any door is opened and closed.

-

Any door is unlocked.



·

Map Lights

·

No. 1 Room Light Assemblies

·

Ignition Key Illumination Light*1


Interior Light Auto Cut When no changes occur in the condition of the lights switches on for 20 minutes, these lights turn off.
·

Map Lights

·

No. 1 Room Light Assemblies

·

Slide Door Step Light*2

·

Slide Door Scuff Illumination Light*3

·

Key Cylinder Light Assembly*4



Models with Back Door Inside Handle Light
Function Outline Lights that Operate

*1: Models with immobiliser system

*2: Models without immobiliser system

*3: Models with slide door step light

*4: Models with slide door scuff illumination light

Door Lock/Unlock-linked
·

When front door is unlocked, the lights that operate turn on.

·

When front doors are locked, the lights that operate turn off.


·

Map Lights

·

Ignition Key Illumination Light*1


Door Open/Close-linked
·

When front door is opened, the lights that operate turn on.

·

When front doors are closed, the lights that operate turn off.


·

Map Lights

·

Ignition Key Illumination Light*1

·

Key Cylinder Light Assembly*2


·

When back door is opened, the lights that operate turn on.

·

When back door is closed, the lights that operate turn off.


·

No. 1 Room Light Assemblies

·

Slide Door Step Lights*3

·

Slide Door Scuff Illumination Lights*4

·

Back Door Inside Handle Light


Power Source-linked
·

When the ignition switch is turned from ACC or ON to off, the lights that operate turn on.

·

When the ignition switch is turned from off to ACC or ON, the lights that operate turn off.


·

Map Lights

·

Ignition Key Illumination Light*1


Room Light Switch
·

When the room light switch is turned to on, the lights that operate turn on.

·

When the room light switch is turned to off, the lights that operate turn off.


·

No. 1 Room Light Assemblies

·

Slide Door Step Lights*3

·

Slide Door Scuff Illumination Lights*4

·

Back Door Inside Handle Light


Delay When approximately 15 seconds elapse after any of the following conditions is met, the lights that operate turn off:
·

A door unlock-linked function is operated.

·

Front door is opened and then front doors are closed when the ignition switch is off.

·

The ignition switch is turned from ACC or ON to off when all the doors are closed.


·

Map Lights

·

Ignition Key Illumination Light*1


Battery Saving
·

When 30 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.

·

The battery saving function is canceled when any of the following operations is performed before the lights are turned off by the function. After the operation is performed, the lights remain on for another 30 minutes and then the lights are turned off.

-

The ignition switch is turned to ACC or ON.

-

Front door is opened and closed.

-

Any door is unlocked.



·

Map Lights

·

Ignition Key Illumination Light*1


·

When 30 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.

·

The battery saving function is canceled when any of the following operations is performed before the lights are turned off by the function. After the operation is performed, the lights remain on for another 30 minutes and then the lights are turned off.

-

The ignition switch is turned to ACC or ON.

-

Back door is opened and closed.

-

Room light switch is turned to on.



·

No. 1 Room Light Assemblies

·

Slide Door Step Lights*3

·

Slide Door Scuff Illumination Lights*4

·

Back Door Inside Handle Light


Interior Light Auto Cut When no changes occur in the condition of the lights switches on for 30 minutes, these lights turn off.
·

Map Lights

·

Key Cylinder Light Assembly*2



Wagon Models
Function Outline Lights that Operate
Actuation Area-linked
·

When the electrical key transmitter enters any actuation area around the doors, the lights that operate turn on.

·

When the electrical key transmitter leaves all of the actuation areas around the doors, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Side Illumination Lights (for Slide Door)

·

Side Illumination Lights (for Rear Quarter Trim)


Door Lock/Unlock-linked
·

When any door is unlocked, the lights that operate turn on.

·

When all doors are locked, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Side Illumination Lights (for Slide Door)

·

Side Illumination Lights (for Rear Quarter Trim)


·

When all doors are locked, the lights that operate turn off.


·

Engine Switch Illumination Light


Door Open/Close-linked
·

When front door is opened, the lights that operate turn on.

·

When all doors are closed, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Side Illumination Lights (for Slide Door)

·

Side Illumination Lights (for Rear Quarter Trim)

·

Engine Switch Illumination Light


·

When rear door is opened, the lights that operate turn on.

·

When all doors are closed, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Side Illumination Lights (for Slide Door)

·

Side Illumination Lights (for Rear Quarter Trim)

·

Slide Door Scuff Illumination Lights

·

Step Light Assemblies


·

When back door is opened, the lights that operate turn on.

·

When all doors are closed, the lights that operate turn off.


·

Luggage Light (No. 1 Room Light Assembly)


Power Source-linked
·

When the ignition switch is turned from ACC or ON to off, the lights that operate turn on.

·

When the ignition switch is turned from off to ACC or ON, the lights that operate turn off.


·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Engine Switch Illumination Light


·

When the ignition switch is turned from off to ACC or ON, the lights that operate turn on.

·

When the ignition switch is turned from ACC or ON to off, the lights that operate turn off.


·

Down Light


Delay When approximately 15 seconds elapse after any of the following conditions is met, the lights that operate turn off:
·

An actuation area-linked function is operated.

·

A door unlock-linked function is operated.

·

Any door is opened and then all doors are closed when the ignition switch is off.

·

The ignition switch is turned from ACC or ON to off when all the doors are closed.


·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Side Illumination Lights (for Slide Door)

·

Side Illumination Lights (for Rear Quarter Trim)


When approximately 40 seconds elapse after any of the following conditions is met, the lights that operate turn off:
·

The driver door/front passenger door is opened and then all doors*A are closed when the ignition switch is off.

·

The shift position is changed from P to any other position when the ignition switch is off.

·

The ignition switch is turned from ACC or ON to off.


·

Engine Switch Illumination Light


Battery Saving
·

When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.

·

The battery saving function is canceled when any of the following operations is performed before the lights are turned off by the function. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.

-

The ignition switch is turned to ACC or ON.

-

Any door is opened and closed.

-

Any door is unlocked.

-

The electrical key transmitter enters any exterior actuation area.



·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Side Illumination Lights (for Slide Door)

·

Side Illumination Lights (for Rear Quarter Trim)


·

When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.

·

The battery saving function is canceled when any of the following operations is performed before the lights are turned off by the function. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.

-

The front door is opened and closed.



·

Engine Switch Illumination Light


Interior Light Auto Cut When no changes occur in the condition of the lights switches on for 20 minutes, these lights turn off.
·

Map Lights

·

No. 1 Room Light Assembly (Front)

·

No. 1 Room Light Assembly (Center)

·

Luggage Light (No. 1 Room Light Assembly)

·

Slide Door Scuff Illumination Lights

·

Step Light Assemblies

·

Vanity Light Assemblies

·

Spot Light Assembly



HINT:

*A: Does not include back door.



b.

Dimmer Function (Wagon Models)

i.

Side Illumination Light

·

The brightness can be adjusted to one of 3 levels each time the room light switch is pressed. (high brightness, medium brightness, low brightness)


HINT:
·

When the brightness is low, pressing the room light switch turns the side illumination light off.

·

When the room light switch is pressed and held, the side illumination light turns off.




ii.

Spot Light

·

The brightness can be adjusted to one of 3 levels each time the spot light switch is pressed. (high brightness, medium brightness, low brightness)


HINT:
·

When the brightness is low, pressing the spot light switch turns the side illumination light off.

·

When the spot light switch is pressed and held, the side illumination light turns off.





c.

Color Change Function (Models with Color Change Function)

i.

The side illumination light can be changed between the following colors by operating the No. 2 room light switch.

·

Clear Blue

·

Amber

·

White




d.

Collision-linked Interior Light Control (Models with Airbag System)

i.

Condition for turning on the interior lights

·

The airbag ECU detects an impact



ii.

Conditions for turning off the interior lights

·

Approximately 20 minutes elapse after the lights are turned on

·

The interior light off operation is performed


HINT:

The interior lights may not turn on depending on the severity of the impact, the type of collision or due to communication malfunctions.




e.

Customization Function

i.

Settings of some functions can be changed as desired by the user. Refer to the Repair Manual for details.