Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2019.06
NM35X0E _56 Audio / Visual / Telematics _078343 PARK ASSIST / MONITORING _0379912 TOYOTA PARKING ASSIST-SENSOR SYSTEM CO CONTROL F

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  CONTROL  TOYOTA PARKING ASSIST-SENSOR CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function

*1: Models with parking assist monitor system or panoramic view monitor system

*2: Models with segment LCD monitor type multi-information display

*3: Models with TFT LCD monitor type multi-information display

*4: Models with parking assist monitor system

*5: Models with panoramic view monitor system

*6: Models with manual transmission

Front Corner Ultrasonic Sensor RH/LH Sends ultrasonic waves to detect stationary objects and outputs a signal to the clearance warning ECU assembly.
Rear Corner Ultrasonic Sensor RH/LH
Rear Center Ultrasonic Sensor RH/LH
Clearance Warning ECU Assembly
·

Determines system operation conditions based on signals input from each switch.

·

Controls operation of the No. 1 clearance warning buzzer, and sends a display request signal, etc. to the radio and display receiver assembly*1 and combination meter assembly, based on stationary object detection data and abnormality judgment.


Toyota Parking Assist-sensor System Main Switch Sends a Toyota parking assist-sensor system on/off signal to the clearance warning ECU assembly.
Combination Meter Assembly
·

Toyota Parking Assist-sensor System OFF Indicator

·

Go to Service Warning Indicator*2

·

Multi-information Display

·

Meter Buzzer*3


·

Receives stationary object detection signals from the clearance warning ECU assembly, and displays Toyota parking assist-sensor system detection on the multi-information display.

·

When the Toyota parking assist-sensor system is off, turns the Toyota parking assist-sensor system OFF indicator on.

·

Sends a customization signal to the clearance warning ECU assembly.*3

·

When a malfunction is detected in the Toyota parking assist-sensor system or the ultrasonic sensors determine that control is not possible, the Toyota parking assist-sensor system OFF indicator blinks, meter buzzer sounds and a message is displayed on the multi-information display to warn the driver.*3

·

When a malfunction is detected in the Toyota parking assist-sensor system or the ultrasonic sensors determine that control is not possible, the Toyota parking assist-sensor system OFF indicator blinks and go to service warning indicator illuminates to warn the driver.*2

·

Sends a vehicle speed signal to the clearance warning ECU assembly.


No. 1 Clearance Warning Buzzer Changes the buzzer sound by controlling the clearance warning ECU assembly, in order to notify the driver of the approximate distance from the vehicle to a stationary object.
Radio and Display Receiver Assembly*1 Displays Toyota parking assist-sensor system detection when a stationary object is detected.
Rear Television Camera Assembly*4 Sends a stationary object detection video signal to the radio and display receiver assembly, based on stationary object detection signals received from the clearance warning ECU assembly.
Parking Assist ECU*5
ECM Sends a shift position signal to the clearance warning ECU assembly.
Main Body ECU (Multiplex Network Body ECU) Sends parking brake switch ON signals to the clearance warning ECU assembly.*6
Central Gateway ECU (Network Gateway ECU) Relays the signal between the CAN communication buses.
DLC3
·

The Global TechStream (GTS) can be connected to read the Diagnostic Trouble Codes (DTCs) of malfunctions.

·

The Global TechStream (GTS) can be connected to change settings as desired by the user.




OPERATING CONDITION


a.

When all of the conditions in the table below are established, the system performs stationary object detection.

Detection Position Operation Conditions

*1: Models with automatic transmission

*2: Models with manual transmission

*3: Operates regardless of the vehicle speed when the shift position is R.

Front Corner
·

Ignition switch is turned to ON.

·

Toyota parking assist-sensor system is on.

·

The shift position is not P.*1

·

The parking brake switch is not on.*2

·

The vehicle speed is approximately 10 km/h (6 mph) or less.*3


Rear Corner
·

Ignition switch is turned to ON.

·

Toyota parking assist-sensor system is on.

·

The shift position is R.


Rear Center



SYSTEM CONTROL


a.

Toyota Parking Assist-sensor System Detection Area

i.

Stationary objects are detected within approximately 600 mm (23.6 in.) of the front left and right corner sensors, within approximately 600 mm (23.6 in.) of the rear left and right corner sensors and within approximately 1500 mm (59.1 in.) of the rear left and right center sensors. Note that there are some areas where stationary objects cannot be detected if they are too close to the bumper. The detection range may also vary depending on the shape of the stationary object.

Front Corner Sensor and Rear Corner Sensor Detection Area
Y240856C01
6.156,5.26 6.313,4.688 6.313,4.688 6.542,4.688 true 0.969,5.188 0.917,4.615 0.917,4.615 0.74,4.615 true 0.573,1.01 0.885,1.167 0.313,0.156 10 false *a 1.354,3.281 1.667,3.438 0.313,0.156 10 false *b 6.552,1.177 6.865,1.333 0.313,0.156 10 false *c 5.76,3.406 6.073,3.563 0.313,0.156 10 false *d 0.385,5.156 0.698,5.313 0.313,0.156 10 false *e 0.406,5.781 0.719,5.938 0.313,0.156 10 false *f 6.625,5.229 6.844,5.427 0.219,0.198 10 false *g 6.646,5.802 6.958,5.958 0.313,0.156 10 false *h 0.229,6.635 0.594,6.844 0.365,0.208 10 false *j 0.854,1.063 1.031,1.281 0.177,0.219 12 false A 6.25,1.188 6.427,1.406 0.177,0.219 12 false A 6.448,2.979 6.625,3.198 0.177,0.219 12 false A 0.635,3.042 0.813,3.26 0.177,0.219 12 false A 6.615,4.625 6.979,4.833 0.365,0.208 10 false *i 0.375,6.635 0.74,6.844 0.365,0.208 10 false *k 0.573,4.531 0.938,4.74 0.365,0.208 10 false *i
*a Approximately 900 mm (35.4 in.) *b Approximately 600 mm (23.6 in.)
*c Approximately 900 mm (35.4 in.) *d Approximately 600 mm (23.6 in.)
*e Approximately 550 mm (21.7 in.) *f Approximately 250 mm (9.84 in.)
*g Approximately 550 mm (21.7 in.) *h Approximately 250 mm (9.84 in.)
*i Sensor Front (Cross Section A) Detection Area (Not Detection Area toward Front/Rear of Vehicle) *j The detection area in the illustration was calculated using a pole with a diameter of 60 mm (2.36 in.).
*k The illustration shown is an example only. - -
V100145

Detection Area - -


Rear Center Sensor Detection Area
Y240857C01
6.396,2.24 6.708,2.396 0.313,0.156 10 false *a 5.51,3.417 5.958,3.625 0.448,0.208 10 false *b (*A) 6.375,5.146 6.688,5.302 0.313,0.156 10 false *c 6.385,5.75 6.698,5.906 0.313,0.156 10 false *d 0.083,6.635 0.396,6.844 0.313,0.208 10 false *e 0.271,6.635 0.51,6.844 0.24,0.208 10 false *f
*A When Target Object is Wall - -
*a Approximately 1570 mm (61.8 in.) *b Approximately 1500 mm (59.1 in.)
*c Approximately 590 mm (23.2 in.) *d Approximately 230 mm (9.06 in.)
*e The detection area in the illustration was calculated using a pole with a diameter of 60 mm (2.36 in.). *f The illustration shown is an example only.
V100145

Detection Area - -





FUNCTION


a.

Toyota Parking Assist-sensor System Operation

i.

The Toyota parking assist-sensor system can be turned on and off using the Toyota parking assist-sensor system main switch.


ii.

A Toyota parking assist-sensor system off indicator is located in the combination meter assembly to make it possible to check that Toyota parking assist-sensor system is off.



b.

Warning Buzzer Mute Function (Models with TFT LCD Monitor Type Multi-information Display)

i.

When the warning buzzer is sounding, the warning buzzer is temporarily muted if the steering pad switch assembly is used to do so.


ii.

When the warning buzzer has been temporarily muted, temporary muting is canceled if any of the following conditions are established.

·

The shift status is changed.

·

The vehicle speed reaches a certain value or higher.

·

There is a sensor abnormality (open/frozen).

·

It cannot be used (CAN communication abnormality).

·

The Toyota parking assist-sensor system was turned off.

·

The ignition switch was turned off.




c.

Abnormality Judgment

i.

When the Toyota parking assist-sensor system is turned on, abnormality judgment is performed on all sensors regardless of the shift position.


ii.

If there is an open or frozen sensor, or if there is a communication malfunction in the clearance warning ECU, a Toyota parking assist-sensor system OFF indicator blinks and a warning is displayed on the multi-information display.*1


iii.

If there is an open or frozen sensor, or if there is a communication malfunction in the clearance warning ECU, a Toyota parking assist-sensor system OFF indicator blinks and go to service warning indicator illuminates.*2

*1: Models with TFT LCD monitor type multi-information display

*2: Models with segment LCD monitor type multi-information display




d.

Toyota Parking Assist-sensor System Settings

i.

The combination meter assembly customization setting can be used to change the volume of the buzzer (3 levels).*

*: Models with TFT LCD monitor type multi-information display



ii.

The Global TechStream (GTS) can be connected to change settings for some functions as desired by the user. Refer to the Repair Manual for details.




DIAGNOSIS


a.

In order to make system inspections easier to perform, a diagnosis function is used in consideration of serviceability. The DTCs of malfunctioning parts can be read by connecting the Global TechStream (GTS). Refer to the Repair Manual for details.