CONSTRUCTION
Air Conditioning Unit Assembly
The following damper servo motors are used.
·
Fresh/Recirculation Mode Door Switching Servo Motor ·
Mode Door Switching Servo Motor ·
Air Mix Servo Motor |
·
Mode Door Switching Servo Motor ·
Air Mix Servo Motor |
A pulse pattern type servo motor that performs control by communicating with the air conditioning amplifier assembly over the bus lines is used for each servo motor. Along with using pulse pattern type servo motors, smart connectors contain ICs that have such functions as communicating with the air conditioning amplifier assembly.
The installation positions for the servo motors are on the side of the blower assembly for the fresh/recirculation damper servo motor, and on the side of the air conditioning unit assembly for the air conditioning radiator damper servo sub-assembly.
| *1 | No. 1 Air Conditioning Radiator Damper Servo Sub-assembly
·
Mode Door Switching Servo Motor ·
Air Mix Servo Motor |
*2 | No. 1 Blower Damper Servo Sub-assembly
·
Fresh/Recirculation Mode Door Switching Servo Motor |
| *a | The illustration shown is an example only. | - | - |
| *1 | No. 1 Rear Cooling Unit Damper Servo Sub-assembly
·
Air Mix Servo Motor |
*2 | No. 2 Rear Cooling Unit Damper Servo Sub-assembly
·
Mode Door Switching Servo Motor |
Pulse Pattern Type Servo Motor
In contrast to the previous type that detects the position by way of a potentiometer voltage, the pulse pattern type servo motor detects the relative position by way of the 2-bit on/off signals.
The forward and reverse revolutions of this motor are detected by way of 2 phases, A and B, which output 4 types of patterns. The air conditioning amplifier assembly counts the number of pulse patterns in order to determine the stopped position.